How to disable Auto Dimming in YOP/YCH/YPM using light sensor.

Question: 
How to disable Auto Dimming in YOP/YCH/YPM using light sensor. Because once you have Auto Dimming Light sensor come with LCD which you can’t change the brightness manually.

Answer:
Please see below instruction how to disable YOP/YCH/YPM light sensor.

Step 1: Remove the external light sensor.

Step 2: Cut the cable with pliers.

Step 3: Use wire strippers to strip the wire.

Short circuit two cables, and connect it to the screen.

• Related Articles

• YCH/YPM/YOP White Screen Check LVDS

  If the OSD LED is green and the screen is White. It is telling the backlight inverter is fine but the LVDS is not fully connected.   1. Green light: Normal display (when OSD green color, but no screen, maybe inverter or backlight unit burned out) 2. ...

• Part No.: CPMW2700IP-PCAP-DC - Case 6-120627-78017 - Question: OSD Auto Adjust Function Procedure.

  OSD Auto Adjust function Procedure. 1. OSD key function Manual / Select button ---red marked + / Increase or - / Decrease button ----yellow marked 2. Pressed Manual / Select button 3. Pressed + / Increase ) or - / Decrease ) button to “ Special “ ...

• Part No. NW119C16e - Problem: All server buttons are inoperative. No server number light, screen flickers yellow/orange.

  Problem: All server buttons are inoperative. No server number light, screen flickers yellow/orange. Diagnosis: PCB Board is defective. See below on how to change the PCB Board. Before your work, please make sure that the power is disconnected. Step ...

• Part No.: SCHW4200HB-SIP-V1 - Case 6-OW-110915 - Issue: Screen flashing on and off constantly.

  Customer Issue: We are having issues 2/3 of the displays where the screen will be flashing on and off constantly and not displaying when required. Can we have your input and any testing that can be conducted on these displays? Solutions: Please turn ...

• Part No. CCHW4300HB-SIP-H - Case 6-120127-77791 - How to remove AD Board

  Steps how to remove AD Board Step 1. Loosed the rear maintenance cover screws. ( blue marked) Step 2. Removed some cables and loosed AD board screws. a. Blue marked : 12VDC power cable for AD board b. Yellow marked : GND cable ( AD board ) c. Orange ...